A professional quality gun which allows precise application from the AquascapePRO pressure pack can of expanding foam for sealing waterfalls and easy securing of rock embellishment.
This gun is used to apply the foam from AquascapePRO Pro Waterfall Foam Sealant 24oz (680g) - 30096
The gun and cans are sold separately
Nozzle wand length: 200mm plus 190mm extension plastic straw & 2x 40mm nozzles inclusions
Step-by-Step Instructions:
- Before putting a can of foam on the gun for the first time, press the trigger down to release any air that may be in the barrel
- Shake the foam pressure-pack can and screw the can to the gun. DO NOT OVERTIGHTEN.
- Squeeze the trigger to allow the foam to fill the barrel
- Adjust the flow by tightening or loosening the flow-adjustment screw found at the back of the gun
- For best results, mist the area to be foamed with water first. The hygroscopic foam setting process is aided with water dampness of the substrate.
- When finished, tighten the flow-adjustment screw fully until the trigger is locked
Maintenance:
- Always keep a can on the gun. Failure to do so will cause the foam to harden in the gun barrel to permanently clog the gun
- The nozzle tip can be cleaned using a wire brush or similar. DO NOT scrape on a rough surface such as the concrete footpath bricks or rocks
- If you prefer to clean the gun between jobs, ready for the next new spray can or the gun barrel is blocked, attach a can of AquascapePRO Pro Foam Gun Cleaner - 22011 to flush out the barrel
- If the ball valve, located in the gun where the can is attached, becomes stuck, use a a thin object such as a pencil to press down on the ball to release it.
See our full range of Aquascape Black Expanding Foam products.
