Elevate 76mm wide QuickSeam Splice tape - 30.48m roll - W56RAC1603

Seaming tape. A full roll, 75mm wide x 30.4m long. Used for lap seam joining of EPDM line

Also available as short piece cut as one length and as a Roll of 7.5m long

Please note:

• For correct application of this tape you must prepare the mating raw EPDM surfaces with QuickPrime Plus EPDM Seam Primer applied with a Scotchbright type plastic scouring pad or Elevate QuickScrubber Tool Set. No other primer liquid is permitted.
• It is critical that the seaming surfaces are not contaminated with sand from the substrate. The use of geotextile underlay or even a 1m wide strip of black builder's plastic under the entire seam if not using underlay will prevent sand contaminants. A rigid board must be dragged along underneath during application if on soft or uneven ground to ensure a solid force can be applied to the seam with the Elevate Seam Rolling Tool. For small on-off jobs the Budget Seam Roller Tool will be sufficient.
• A crayon mark is placed approximately 20mm out from the overlap edge. This means that the placement of the backing tape to this crayon mark will ensure that there is a minimum 5mm of exposed seam tape when the overlap is placed and rolled into position - see in the video below
• When overlapping Seam Splice tape, Elevate Guidelines suggest the application of a Elevate QuickSeam FormFlash patch along with the use of Elevate Lap Sealant HS over the compromised overlap as may have the potential of a capillary leak.