Elevate EPDM Rubber QuickSeam Splice Tape Kit - W56RAC16909L
Stock Availability:
64
SKU:
W56RAC16909L
$265.01
Genuine Elevate kit for joining EPDM pieces. Enough for 7.6m of lap seaming.
Also sold as "Pondliners Elevate Tape Joiner Kit 7.5m"
Please watch the Instructional Videos below.
Genuine Elevate kit for joining EPDM pieces. Seam roller may vary from image
Fast, simple and easy to install, it requires no heat and no mess as it uses an adhesive tape to join the EPDM rubber liner in six steps.
The kit can join up to 7.6 metres.
Includes:
- QuickSeam Primer (supplied as either 2x 4fl oz cans or 1x 250ml can)
- QuickSeam Splice Tape (25ft / 7.62 metres)
- QuickSeam Application Tool (handle and pads)
- Roller (may vary from image)
- Complete installation instructions
Please note:
- For correct application of this tape you must prepare the mating raw EPDM surfaces with QuickPrime Plus EPDM Seam Primer applied with a Scotchbright type plastic scouring pad or Elevate QuickScrubber Tool Set. No other primer liquid is permitted.
- It is critical that the seaming surfaces are not contaminated with sand from the substrate. The use of geotextile underlay or even a 1m wide strip of black builder's plastic under the entire seam if not using underlay will prevent sand contaminants. A rigid board must be dragged along underneath during application if on soft or uneven ground to ensure a solid force can be applied to the seam with the Elevate Seam Rolling Tool. For small on-off jobs the Budget Seam Roller Tool will be sufficient.
- A crayon mark is placed approximately 20mm out from the overlap edge. This means that the placement of the backing tape to this crayon mark will ensure that there is a minimum 5mm of exposed seam tape when the overlap is placed and rolled into position - see in the video below
- When overlapping Seam Splice tape, Elevate Guidelines suggest the application of a Elevate QuickSeam FormFlash patch along with the use of Elevate Lap Sealant HS over the compromised overlap as may have the potential of a capillary leak - see in the video below
- Where multiple panels of EPDM meet resulting in a tee or cross intersection of overlapping QuickSeam Splice tape, Elevate Installation Guidelines suggest the application of a Elevate QuickSeam FormFlash patch along with the use of Elevate LapSealant HS over the compromised overlap as may have the potential of a capillary leak.
Write Your Own Review