Luise GL90 Float Switch with 10m PVC cable
Luise GL90 Float Switches Australia - Made in Italy Over the years we have sold these reliable units, we have never had a reported failure or return. This model has bared wires at the end. It requires installation by a licensed electrician. See the wiring legend image of the float which indicates wiring for either emptying or filling purposes.
Float switches are used to turn electric pumps on and off, & are totally dependent on the liquid or water level. They are very easy to install and can be connected to any small or large pump.
Common applications:
- Basement sumps where unwanted water is collected during rainfall
- Refilling header tanks automatically, when low, from a lower storage tank
- Ponds which are often left unattended for long periods. Here the float switch safeguards the pump from burn-out when the pond is inadvertently emptied by evaporation or leaks.
Please Note - For Reliability:
- Float switches should ONLY be hard wired into a junction box. Avoid plug-connection into a power-point - switch off or disconnect means no pump!
- Tethering the cable is preferable to using a counterweight
Rated: Italian Quality Mark (IMQ) 10(4)A 250V~ with 16A micro switch
10A = resistivity interruption power
(4) = inductive interruption power
Dimensions of float: 100 x 90 x 45mm
Minimum recommended sump dimension: 300 x 300 x 400mm deep (with cable tethered to the side & using a small pump)
